Hi,
I would like to be able to connect a cable from [outlet~] -> [*~] -> [inlet~], without using an object like [catch~]

The reasons is that each time I duplicate the subwindow I get duplicated feedback lines, errors. I would like to not need to change the name all the time (feedback2, feedback3...).

Or if there is another better way to make it possible to just connect without getting the DSP loop error. I want to connect by cables since that suits my workflow in this case.

operator.pd

Thanks!

this should work

@Balwyn said:

this should work

I was never able to get $0 to work in a [pd ......] subpatch, only in an abstraction... is that right, or did I miss something?

hjh

@ddw_music is right!
@cfry I didn't read your question properly, you should turn your subpatch into an abstraction then each instance will have a unique feedback loop using the $0 prefix

Another solution with pack~ + unpack~ from the zexy library.

I removed the adsr object from the abstraction to make it work for me.
operator-Modif.pd

Gerard

Hi, thanks for the input.

I decided that adding new throw/catch variables is quite comfortable after all. If I want it very visual I can even just put the objects side by side.

@Balwyn I tested to make an abstraction and also tried to clone it but I did not succeed. Probably I would just need to spend some more time on it.

@paresys I could not install the zexy library from deken, maybe I have messed up my paths. Will try later.