So I am trying to figure out how to use a slider to determine which sample is in use in a granular synth. I'm sure there must be a way but its been a while since I've been using pd and I can't work it out!

In vaguegly psuedo code terms i'm thinking something like:

If slider is between 0 - 25 send bang to message 1
If slider is between 26 - 50 send bang to message 2
If slider is .......etc etc

Any ideas/help is greatly appreciated

Best,

Joe

assuming your slider is outputting a value from 0-99, do something like:
output of slider - > divide by 25 -> INT
this will give you a value from 0 to 3.
the you can use SEL 0 1 2 3 to send a bang to a different message for each range.

@maltwhisker Helo..... @nuromantix has given you the correct answer, but it might be easier to use the radio button to select the sample (rather than a fader)......
It will give an output 0-n...... so your sel object would be the same......... and if you open its properties you can have as many buttons as you need.......
David.

@nuromantix @whale-av thanks guys you rock! Exactly what I needed