Hello!

I'm trying to get PDuino working in a setup where I have Arduino reading an analog input and also controlling a relay on the digital output. I have tried the StandardFirmata sketch for Arduino but it doesn't seem to be able to read the analog input with this sketch (it controls the digital output no problem with this however). When I use the AllInputsFirmata instead, it reads the analog inputs just fine but I'm getting no response on the digital outputs.

Is there perhaps something where you can't use analog inputs and digital outputs at the same time? Could I be doing something else wrong? I've tried all the other Firmata sketches that come with the Pduino setup files (out of desperation!) but with no success. Any help greatly appreciated!

@evaekblad If it is anything like an RPI you need to tell pins whether they should be inputs or outputs.
"AllInputs" sounds like it will never switch a pin to output..... but I have no idea.
This is in French unfortunately....... https://fr.flossmanuals.net/puredata/arduino-et-pd/
There is a link to a patch that will do what you want.
You will need StandardFirmata.
It is quite simple.
[arduino-test] allows you to set all the pins as desired.
Actually, I just found more detailed instruction in English...... http://write.flossmanuals.net/pure-data/starting-pduino/
David.

Thanks David, I'll give it a look and run through it! However I have a feeling that there must be something I'm doing at my end that's causing the problem - from that page it seems like StandardFirmata should theoretically work, but it's not doing that when I implement it. I thought others might have experienced this problem, but perhaps there aren't that many people still using Pduino in 2019!