Hi everyone!

Our lab has made a new high-performance embedded platform called Bela (http://bela.io) which is designed for creating digital musical instruments and interactive audio systems. We've been developing this for the past two years, and we just launched it on Kickstarter:

https://www.kickstarter.com/projects/423153472/bela-an-embedded-platform-for-low-latency-interact

The most important unique feature of Bela is that it has extremely low latency of less than 1 millisecond between action and sound, which is a lot faster than anything else out there. There are also some useful features for profiling sensors and a built-in browser-based development environment. Basically it is the platform I have always wanted for my own audio projects and instrument building, and now we're excited to be launching it to a broader community of musicians and engineers.

The board doesn't run Pd directly, but patches can be compiled using Enzien Audio's Heavy compiler - so you can address all sensor IO's from the patch.

The project is open-source hardware and software, and the campaign is run through the university.

Cheers,
Chris

Bela tech details:

Audio: 16-bit stereo audio I/O at 44.1kHz
Audio power output: 2x 1W 8ohm speaker amplifiers (available when powered from DC jack)
Analogue In: 8x 16-bit analogue inputs at 22.05kHz
Analogue Out: 8x 16-bit analogue outputs at 22.05kHz
Digital channels: 16x digital GPIO at 44.1kHz or 88.2kHz
Analogue I/O is also software configurable to give 4 channels at 44.1kHz or 2 channels at 88.1kHz

More info:
http://bela.io
http://twitter.com/BelaPlatform
https://www.facebook.com/belaPlatform/

d'oh! I don't know how I missed that part of the help file. Thanks!

Hullo,

Has anybody noticed consistent noise (~20hz) when using the [line] object to do linear interpolation on control rate signals? See the attached patch for more clarification -- basically I get less noise when literally setting the frequency of the oscillator at a rate of 1ms than when interpolating between messages at a rate of, say, 30ms.

rateTesting.pd

In case you're wondering -- I know using signal-rate line object is the way to go in these situations, but I'm curious to understand what's causing this noise, as it's not the behaviour I expected.