Hej Hej..!

I have a small project to connect my arduino with the solenoide control, with a attached board, and them make a sequencer in the Pd, for the solenoides, and control this sequencer by the APC. That is also sending messages to ableton live.

Well...so far I got the solenoides working fine with pd and arduino, and also a sequencer that send messages to the digital pins...

But i couldn´t find a way yet, to select a particular note in the APC to mark only that specific step.

the idea is:
when "pad1" is pressed, send 1. when is the other, do nothing.
when "pad1" is pressed again, send 0.

i mix a patch.
until now is like this:::

http://www.pdpatchrepo.info/hurleur/sequencer3.pd

u guys got it?
I hav some problems with sync also... but Im sending form ableton to pure data...

this was some results after meeting with this guys .. http://netpd.org/positronic/ in berlin

same same...
ableton is receiving the notes as pd. but so far no LED´s in the scene...