Hi, I've a project to control a step motor trough pduino, I've tried with the Arduino stepper library and the system work, but i don't know how can i translate to a PD patch....

There is same example around Or someone have an idea to how control a 4wire step motor trough PD

Thanks...

Kino

you will need some extra hardware.
google adafruit motor shield.

then you can send a bang to a digi - pin and the stepper will go one step in a direction. and on another pin, one step in the other. u can use pduino then.

Yes, I'm using a SN754410NE Driver and I've think in this possibility with pduino.... I'll try later, and I'll say you if works.

Thanks

It works, but i can't use the sames speed of the stepper library of Arduino....
Someone have an idea ?