Has anyone experienced the CPU load going up gradually in a patch when the dsp is switched off? When my dsp is on, the load metre is around 29-40 percent. When I turn it off, it falls to 4 percent then starts climbing gradually in steps until it can go well into the 370 percent zone, and then crash (that's only if I turn my back for ten minutes). The gradual climb goes up say 3 percent then down 2 percent, and then up 3 again and so on, rather than just a constant climb. I thought it might be some kind of feedback I have in the patch, but can't understand why this wouldn't occur when the dsp is on.

maybe upload a patch that causes this?

Hello steffen,
I found the problem with that dsp load increase. Basically I had a bunch of table reading through counters which I were in conflict. It doesn't explain why the load increased when dsp was turned of, but I sorted it out.
Thanks for the offer of uploading the patch, but it was such a mess I was embarrassed to.
-George

[vline~] will keep eating messages when it is swithced off, until it becomes so full it bursts your cpu.