Hello,

I have a problem with using pd and MIDI yoke.
The thing is that I am sending MIDI information from reaktor through MIDI yoke to pd.
For a while everything goes fine after a few seconds things go wrong.
I am using different midi-controllers and it seems that after a while information from the different controllers get "messed-up".
I am sending MIDI through port 1 of MIDI Yoke and receiving from the same port in pd. This is the only port that I am using.
Now I found out (by opening pd in DOS) that I get a MIDI feedback, but I don't understand why...
Also when I set-up the midi port I get the message that using MIDI in windows is dangerous:
Warning: midi input is dangerous in Microsoft Windows\; see Pd manual).

Can somebody help me pleezze.

So is this what you have set up?

PD->MIDIYoke1->Reaktor

Reaktor->MIDIYoke1->PD

If so, that will make a MIDI Loop

Change one of your signal chains to MIDIYoke2 e.g.:

PD->MIDIYoke2->Reaktor

Reaktor->MIDIYoke1->PD

The only set-up I have is:

Reaktor -> MIDIYoke1 -> Pd.

I found out that with the Pd-Vanilla I dont have this problem. It also don't display the warning. For me this is a good solution, I just don't understand why.