Hi guys,

i was searching for a library to use the Wii remote input to manage some patches in PD, then i found Wiilib, but apparently the web site of wiilib is offline.

Has someone tested Wiilib? There is another way to get this library?

Thank you very much,

I usually use OSC DarwiinRemote

It works just like OSCulator but its free

I thinks its cross platform too

darwiinremote is not cross platform. it is for mac only.

I don't think any of the Wiimote stuff is cross-platform, which is a shame. It's a really useful controller.

My mistake sorry!!!!!

Hi again,

no one has a simple demo patch just to learn the basics? Anything that is working, using wiilib, would help very much.

Thx.

in the archive file there is a single .pd file that shows everything !

Do you mean this file "wiimote_pd-0.1.5.tar.gz" that you uploaded?

I'm could not extract it, did someone get it extracted?

I got the newest version, and is everything working fine.

Thx!

http://www.pdpatchrepo.info/hurleur/wiimote-0.3.2.tar.gz

Buuut,

when i try the help patch, some stuf dont work properly.

I successfully connected my wiimote, the LEDs and rumble responded to the patch. But, when i tried the Acc and IR report, there was a "no method for 'report'" message. Does, someone know this problem, is this version deprecated, about the report message treatment?

Someone used this version of the extension? The report type message is not working properly.

Does anyone use this version of wiilib? i still did not get any reference for my problem.

I coudn't open your archive. You mentionned the same problem with the one I posted previously ... so I tried now to download 'mine' and open it and ... doesn't work neither.

Modest conclusion : something goes wrong with the upload function ?

I re-uploaded it here : http://www.sendspace.com/file/tpmdj2
BUT this is a compression of the folder after my install (the original archive can be found, if you ask me to, as it is on another pc), so if you want to use it to compile on your computer maybe you'll have to clean up some config files in the folder before.

Nau

i downloaded your files but this version could not be load by Pd. Everything looks right, the library compiles correctly, but Pd does not load.

So here is the 'virgin' archive, the one from which I installed it, just in case : http://www.sendspace.com/file/lvp20x .

Which version of Pd do you use ? Mine is pd-extended 0.42-5 .

Nau